bladox.com

[LLcoolR]

i tried to fit the turbosim and the at&t-sim as good as possible. i only see "no sim" in the upper left corner of the springboard.

after typing turbo-info in winscp terminal i always get this error:

/bin$ turbo-info
initializing modem
AT+CPMS="SM","SM"
AT+CPMS="SM","SM"
ERROR
AT+CMGF=0
AT+CMGF=0
ERROR
AT+CPMS?
AT+CPMS?
ERROR
modem initiated
Mobile Phone/Serial Cable Communication Error

what can I do now?? any hints?? i do not know any further ... please help me in this case.

Thank you all!

[matthew81]

i have the same problem!!

my iphone is a 1.1.2 OOTB with bot 4.6

- downgrade to 1.1.1
- installed bsd subsystem, open ssh, community sources
- copyed files folder "turbosim" on the root of iphone, setup all files on 0755
- i have restarted iphone with Turbosim + Sim aT&t
- when i tupe "turbo-info" the phone answer so:

# ./turbo-info
initializing modem
AT+CPMS="SM","SM"
ERROR
AT+CMGF=0
ERROR
AT+CPMS?
ERROR
modem initiated
Mobile Phone/Serial Cable Communication Error

why?? help me please!

[LLcoolR]

finally i got it!!!!!! my iphone works with turbosim

just try to fit the turbosim as good as possible on the at&t sim!!!



you can also check if your turbosim is on its correct place (when "commcenter" is enabled!):

take out the original sim - "no sim" should pop up
now put the (not yet programmed) turbosim on the at&t-sim and insert the whole slot back into the phone

now "no sim" should swap to "...."

may the force be with you!! good luck!!