bladox.com

[jbsolutios]

Could you tell me a bit more about it and how you persuaded them to do it please?

I do not have blackberry and I am not sure what multisim is (sorry).

Many thanks

JB

[michaelffm75]

i have the same problem

a new T-Com sim with the new "face"

Turbosim lost signal and then the sim

i tried dragons swap trick - but it didn´t work

Card is a n3 modell

thanks for help

[pz]

We (bladox) still don't know. Some people reported N3 working fine with TSIM+iPhone. So it may be elsewhere/some other issue.

[michaelffm75]

ok,
now i checked all german available sims

ePlus,o2,vodafone

all works fine with my programmed Tsim

only the new faced t-mobile n3 sim

[zwan]

Are there any new information how to solve this issue? I'm using an n3 Sim from T-Mobile Germany and FW 1.1.2. Same problems as reported in the posts above.

[michaelffm75]

hello Bladox gus
any news about N3 sims?

[pz]

We don't do much. In the beginning we were interested but then some people reported it works so we gave up. But maybe all N3 cards are not the same - it's quite common, all looks the same but it can be different chip, different firmware, etc. Same can be on iphone side - all devices looks same but can be dfferent stepping/version. So we need one such N3 card that is 100% known it's not working.

[michaelffm75]

ok,
i call T-mob and ask if the can change my card because it´s not working in my build in card phone and such blabla

when the change the sim i send my to you that u can check it up


greetz

[pz]

[kudu]

I would be great to get a solution for the problem. I just got my Turbosim today and everything is working fine , but the Sim is losing contact to the T-mobile network after 2 minutes.

Iphone 1.1.2. OOB
German T-mobile N3 SIM


Thanks

[pz]

[zwan]

I ordered a new sim and tried it today (again T-Mobile Germany, again n3 Simcard). I got the same results as before: iPhone connects, after about one minute it loses signal for a few seconds. Connecting and losing signal in turn for about another minute. After about two minutes signal drops completely and iPhone says "no sim installed".

I had the same issue with 1.0.2, 1.1.1 and 1.1.2 so it doesn't seem to be a fw issue.

Strange that nobodoy seems to have a clue.

[pz]

[tsetse]

I have the same issue.

iPhone UK fw 1.1.2 with TurboSim

After putting in the TSim the phone connects to my provider (yesss/Austria). It has good service for about one minute. Making calls works well.
Then the service drops (the little lines disappear but it still displays the name of the carrier). About a minute later the phone states: No SIM installed.

Pulling out the SIM and put it back in makes it work again but the same thing follows after a while.

I also thought that it might be a mechanical issue so I took well care about a good fit of my own SIM with the turboSim and cleaned the contacts. Still the same thing.

What would you suggest? Should I try an other SIM card?

[luckytanke]